Estimation of circulating bovine leukemia virus levels using conventional blood cell counts

Bovine leukemia virus (BLV) is widely prevalent in Japanese dairy farms. To control BLV infections in Japan, segregating or managing cows according to their proviral load (PVL) is a rational strategy. This study was conducted to establish a quantitative procedure for estimating blood PVL per microliter using a statistical model to offer a cost-effective alternative to the conventional quantitative real-time PCR method. In total, 250 Holstein cows infected with BLV were identified from 10 commercial dairy farms. Information on age was collected and blood samples were tested for white blood cell and lymphocyte counts and PVL using PCR. Generalized linear models with quasi-Poisson errors were used to estimate PVL by selecting age, logarithm of lymphocyte count, and their interaction term as explanatory variables. To evaluate the model, blood samples of 92 BLV-infected Holstein cows from 2 other commercial dairy farms were tested, and measured PVL values were compared with estimated PVL values by the model. The logPVL per microliter was modeled by positive associations with log lymphocyte count and age and a negative association with the interaction term. In the evaluation, measured PVL values had a strong correlation with estimated PVL values (Spearman's ρ = 0.87). In conclusion, our model provides a cost-effective and more rapid alternative to the conventional method to facilitate test and segregation or management of BLV-suspected cows.     

Economic Evaluation of Power System Flexibility by Commercial Air Conditioner Control with Large Penetration of Photovoltaic Generation

High penetration of intermittent renewable energy such as photovoltaic (PV) and wind power could cause shortage of power system flexibility. Demand response is expected to help supply ancillary service instead of the conventional power plant. Commercial air conditioners are a promising responsive load for demand response because they account for a large proportion of power consumption in the power system. We calculate a system operation cost and hourly operation pattern of each power plant by using the optimal power generation model considering flexibility supply from controlling commercial air conditioner. We obtained the following results as an effect of commercial air conditioner control. (1) The power generation of oil fired power plants decreases at peak time and annual fuel cost of oil fired plant is reduced by approximately 30% at most in Kanto area. (2) The percentage of rated operation mode of LNG combined cycle plants increases. (3) Curtailed energy rate of PV decreases because a power storage amount by pumped hydropower generation increases. (4) Required battery capacity to reduce PV curtailed amount decreased by combining battery energy storage system in case of high penetration of PV.     

Domestic demand-side response with heat pumps: controls and tariffs

ABSTRACT

Electric heat pumps feature prominently in projected energy transitions in the UK and elsewhere. Owing to their high electricity consumption, heat pumps are viewed as important targets for demand-side response (DSR). Findings are presented from a field trial of a new control system that aims to optimize heat pump performance, including under time-varying tariff conditions. The trial involved monitoring 76 properties with heat pumps, but without dedicated heat storage; 31 of these received the control system. Interviews were conducted with a subsample of 12 participants. The controller successfully evened out electricity demand over the day (reducing the evening peak), but this was associated with increased late night and daytime temperatures. Interview participants reported some disturbance owing to overnight heating and noise, as well as usability issues with the controller interface and hardware. These issues present risks to the future acceptability of such systems. While the system delivered short-term demand reductions successfully, longer-term demand shifting risked causing unacceptable disturbance to occupants. Future control systems could overcome some of the issues identified in this pioneering trial through more effective zoning, using temperature caps or installing dedicated heat storage, but these may either limit the available flexibility or be challenging to achieve.     

考虑节点过载的碳排放空间关联系统级联失效模型

为提高突发事件级联失效对现实碳排放关联系统破坏程度的评估可信性，在传统复杂网络的"负载-容量"级联失效模型基础上，考虑个体成员对负载的冗余能力，提出一种过载失效概率，构建了考虑节点过载状态的级联失效模型，并基于节点特性提出了6种过载节点负载分配策略。仿真结果表明：在过载节点负载分配策略中，综合分配策略整体上较优，能够有效控制级联失效的规模，增加网络鲁棒性；在一定范围内提升过载参数有助于降低级联失效的影响，但提升到一定程度时改善效果不明显；在不同负载分配策略下，剩余系数存在一个最优值，容量可调参数存在最优区间，可以使碳排放关联网络保持较好鲁棒性的同时，花费较小的构建成本，其中紧密度分配策略对应的网络构建成本较高。     

The validation and further development of a multidimensional cognitive load scale for virtual environments

Measuring cognitive load is important in virtual learning environments (VLE). Thus, valid and reliable measures of cognitive load are important to support instructional design in VLE. Through three studies, we investigated the validity and reliability of Leppink's Cognitive Load Scale (CLS) and developed the extraneous cognitive load (EL) dimension into three sub-scales relevant for VLE: EL instructions, EL interaction, and EL environment. We investigated the validity of the measures using the Partial Credit Model (PCM), Confirmatory Factor Analysis (CFA), and correlations with retention tests. Study 1 (n = 73) investigated the adapted version of the CLS. Study 2 describes the development and validation of the Multidimensional Cognitive Load Scale for Virtual Environments (MCLSVE), with 140 students in higher education. Study 3 tested the generalizability of the results with 121 higher education students in a more complicated VLE. The results provide initial evidence for the validity and reliability of the MCLSVE.     

Effect of heat treatment and zircon addition on the properties of low-cement castables based on recycled alumina grog

In this investigation, low-cement castables were prepared using 70% alumina grog aggregates obtained from crushed alumina brick waste. The aggregates were thermally treated at 1550 °C for 3 h. Four types of low-cement castables were prepared with various types of aggregates (alumina grog with or without thermal treatment) and fillers (with or without zircon addition), and they were evaluated in terms of their physical, thermal, and chemical properties. Microstructural analysis via scanning electron microscopy (SEM) was performed on the castables before and after slag attack. Compared to the other fabricated castables, the thermally treated alumina grog castables with zircon showed better physical properties, such as a higher bulk density, cold crushing strength, and modulus of rupture and a lower apparent porosity and water absorption. In addition, they had a higher positive linear thermal expansion, refractoriness under load, permanent linear change, and hot modulus of rupture. The results of the SEM with energy dispersive X-ray analysis of the prepared castables confirmed that the mullite and anorthite phases were predominant when zircon was not added and the zircon–mullite phase additionally appeared upon the incorporation of zircon. A quantitative elemental analysis via X-ray fluorescence spectroscopy was employed to determine the composition of the castables. X-ray diffraction analysis showed that the alumina grog castables had a high mullite and low anorthite content, and the thermally treated alumina grog had a high anorthite, low mullite, and high zircon content. The improvement in the mechanical and thermo-mechanical properties of the castables with thermally treated alumina grog and added zircon can be attributed to the formation of the zircon–mullite phase with a low mullite phase content.     

Effects of external light load on posture and foot pressure distribution in young adults: A pilot study

Holding an asymmetrical load, like a rucksack, grocery bag, or travel backpack, is a part of daily and occupational activities. This pilot study was aimed to determine the effects of light, asymmetrical, handheld load on the body posture and foot pressure distribution in young adults. Thirteen young volunteers, free of any injury or pain, took part in the study (aged 21.53 ± 1.10 years). All the study participants were right-handed. An additional load (4 kg, placed in the rucksack) was asymmetrically held in each hand while standing still. For evaluation of the posture and foot pressure distribution, the investigation focused on three positions, i.e., no-load, a rucksack in the right hand, a rucksack in the left hand. We used a surface topography system and force platform for evaluation of the body posture and foot pressure examination, respectively. The results showed that the main changes in the body posture caused by an external load application manifested in trunk imbalance. The trunk was shifted in the direction opposite to the load. Trunk imbalance changes were statistically significant in all three comparisons (p = 0.001). Interestingly, changes in the rotations and lateral deviation seem to be dependent on the hand dominance. Greater foot pressure was observed on the loaded limb (p < 0.01), and highly significant differences were noted between the left and right foot in both loaded postures (p < 0.001). Further research needs to be done to check if lateralization is connected with body posture while holding an external load.     

基于跨临界CO2热泵的茶叶生产能源系统负荷削减潜力

乡村产业中的化石能源设备逐渐被电能技术替代，引起了乡村负荷波动增大、部分时段产生集中高负荷的问题。为了解决以上问题，将低品位清洁能源应用至乡村的茶叶生产中，针对烘茶全过程的工艺要求提出了跨临界CO₂热泵烘茶技术；并以某茶叶生产乡村为对象，对其代表台区的全年日用电量及产茶日负荷进行了分析，得出采用CO₂热泵烘茶后其负荷得到大幅度削减，整体可降低至原负荷的39.6%~46.8%，峰值负荷与平时负荷的比值由原本的13.6降至5.4~6.2。跨临界CO₂热泵应用至农产品生产中可有效缓解乡村供电压力。